NC State University  |  campus directory  |  libraries  |  mypack portal  |  campus map  |  search ncsu.edu

Aug 15 2014

Free Workshops for Makers and Creators at the Libraries

Do you want to build a robot that interacts with Twitter, a banana piano, or your own wearable electronics project? Are you interested in learning about 3D Printing but aren’t sure where to start? The Libraries are offering several exciting Makerspace workshops this semester that will provide an awesome introduction to a variety of innovative technologies. All workshops are free for all NCSU students, faculty, and staff, and no prior experience is required to participate!

Articulated Hand holding an LED

Register here for workshops:
Getting Started with 3D Printing - Friday Aug. 29, 2-3:30pm, Hunt
Introduction to Arduino & MaKey MaKey - Thursday Sept. 4, 6-7:30pm, Hill
Getting Started with 3D Design - Friday Sept. 12, 2-3:30pm, Hill
Getting Started with 3D Printing - Tuesday Sept. 30, 6-7:30pm, Hill
Introduction to Arduino & MaKey MaKey - Friday, Oct. 3, 2-3:30pm, Hunt
Getting Started with 3D Design - Thursday Oct. 9, 6-7:30pm, Hunt
Introduction to Arduino & MaKey MaKey - Tuesday Oct. 21, 6-7:30pm, Hunt
Spooky Sounds with Arduino - Tuesday Oct. 28, 6-7:30pm, Hill

A full calendar of workshops is also available at go.ncsu.edu/makerworkshops